CPU: div instructions available: patching division code CPU: ARMv7 Processor revision 4 (ARMv7), cr=10c5383d
Also please post content of /boot/config.txt file. Please post output of dmesg terminal command. (02-15-2021, 05:45 PM)BlueWave Wrote: What CAN module do you use? Did you configure it properly? In your case can0 interface is not detected - it means that CAN module is not properly connected or not properly configured. Maybe because the idrive Controller got no ground fo the can bus? (i connected the ground of the Lab Bench power supply to the pi´s ground for the same potencial) it doesnt matter if j1 is bridged or not, it doesnt work either. Now when i want to start the service with controller_service /home/pi/.openauto/config/openauto_controller_service.ini the pi says me that he is unable to map the interface for idrive : can0Īt this point i am stuck.
home/pi/.openauto/config/openauto_controller_service.ini I connected the controller like this: Īnd i wrote these lines from the bluewave forum ( ) in this folder: So now i figured out the pin connections on the controller for vcc and and can bus. But i am an absoloutely newbie in this theme with rapberrys etc. Hello i wanted to retrofit the iDrive gen 1 controller in my car.
0 kommentar(er)
